MXCI Messages (15000 through 15999)
HP NonStop SQL/MX Messages Manual—640324-001
15-81
Recovery. Retry the operation.
SQL 15816
Cause. MXCI was unable to disconnect from the MXCS server.
Effect. The operation fails.
Recovery. Retry the operation.
SQL 15817
Cause. You tried to change the mode to MXCS while already in MXCS.
Effect. None.
Recovery. None. This is an informational message only.
SQL 15990
Cause. You specified an invalid character set name for SQLCI attribute
TERMINAL_CHARSET in MXCI.
Effect. None.
Recovery. Specify a valid character set name for the TERMINAL_CHARSET attribute
and resubmit.
SQL 15991
Cause. A new report definition command(s) has been specified. The report is being
started from the beginning.
Effect. A new report is being generated.
Recovery. None.
15816 An internal error occurred - unable to get a valid MXCS
Destructor.
15817 The current mode is MXCS.
15990 Character set name for SQLCI attribute TERMINAL_CHARSET
is not valid.
15991 Because of the new report definition command(s), the
report is being started from the beginning.
To Next Page