HP NonStop SQL/MX - Page 541

Utility Messages (20000 through 23099)
HP NonStop SQL/MX Messages Manual—640324-001
18-65
SQL 20257
Where table-name is the name of the table specified in the MODIFY command.
Cause. You attempted a partition management operation other than moving an entire
partition to a new location.
Effect. The operation fails.
Recovery. None.
SQL 20258
Where table-name is the name of the table specified in the MODIFY command.
Cause. You specified the WHERE clause in the request to move the partition of a
system-clustered base table to a new location.
Effect. The operation fails.
Recovery. None.
SQL 20259
Cause. An unexpected error was detected.
Effect. The operation fails.
Recovery. None. Contact your service provider.
SQL 20261
Where object-name is the name of the object.
Cause. In the WHERE clause, you did not specify the partition in the request to move
the partition to a new location. When the object has more than one partition, you must
specify the partition.
Effect. The operation fails.
20257 This partition management operation is not supported
for system-clustered base table table-name.
20258 The WHERE clause cannot be used with table-name because
it is a system-clustered base table.
20259 An internal PURGEDATA error occurred.
20261 The WHERE clause must be used with object-name because
it has more than one partition.