6. Clean the face and edges around the ink nozzle area with the swab, as shown
below.
1 Nozzle plate (do not clean)
2 Face and edges around the ink nozzle area
CAUTION: Do not clean the nozzle plate.
7. Insert the ink cartridge into its cradle compartment at the same angle at which you
removed the old ink cartridge.
8. Close the ink cartridge latch. If the cartridge is inserted correctly, closing the latch
gently pushes the cartridge into its cradle compartment. Press the latch to make
sure it is seated flat on the cartridge.
9. Repeat if necessary for the other ink cartridge.
10. Close the front access cover and plug the power cord into the back of the device.
11. Wait for the carriage to complete the ink cartridge initialization routine and return to
the home position at the left side of the printer before using the printer.
NOTE: Do not open the front access cover until the ink cartridge initialization
is complete.
12. Align the ink cartridges. For more information, see Align the ink cartridges.
Replace the ink service module
The replaceable ink service module holds waste ink from the black ink cartridge. When
the ink service module is almost full, the printer lights prompt you to replace it. For
more information, see
Control panel lights reference. When you are notified by the
control panel that the ink service module is full, contact HP support to obtain a new
module. For more information, see
HP support. If you have a new ink service module,
install it immediately by following the instructions that came with the module.
Advanced ink cartridge maintenance 57
To Next Page
Loading...
