Light description/Light pattern Explanation and recommended action
three seconds, the left and right ink cartridge
lights are on or blinking.
If no paper jam exists, press (Resume
button). If this does not work, try turning the
printer off and then on again, and resend
the print job.
Power light blinks, Resume light blinks. After
pressing and holding the
(Cancel button) for
three seconds, the left ink cartridge light is on,
and right ink cartridge light is blinking.
Ink service module is almost full.
The replaceable ink service module holds
waste ink from the black ink cartridge.
When the ink service module is almost full,
contact HP support to obtain a new module.
For more information, see
HP support.
If you have a new ink service module, install
it immediately by following the instructions
that came with the module.
For more information, see
Replace the ink
service module.
Power light blinks, Resume light blinks. After
pressing and holding the
(Cancel button) for
three seconds, the left and right ink cartridge
lights are blinking.
Ink service module is full.
The replaceable ink service module holds
waste ink from the black ink cartridge. The
ink service module is now full. The printer
will not be able to print with the black ink
cartridge until the ink service module is
replaced . Contact HP support to obtain a
new module. For more information, see
HP
support.
If you have a new ink service module, install
it immediately by following the instructions
that came with the module.
Chapter 4
(continued)
68 Solve a problem
To Next Page
Loading...
