Understand the network configuration page (some models
only)
If the device is connected to a network, you can print a network configuration page to
view the network settings for the device. You can use the network configuration page
to help troubleshoot network connectivity problems. If you need to call HP, it is often
useful to print this page before calling.
Network Configuration Page
1. General Information: Shows information about the current status and active
connection type of the network, and other information, such as the URL of the
embedded Web server.
2. 802.3 Wired: Shows information about the active wired network connection, such
as the IP address, subnet mask, default gateway, as well as the hardware address
of the device.
3. 802.11 Wireless: Shows information about the active wireless network connection,
such as the IP address, the communication mode, the network name,
authentication type, and signal strength.
4. mDNS: Shows information about the active Multicast Domain Name System
(mDNS) connection. mDNS services are typically used on small networks for IP
address and name resolution (through UDP port 5353) where a conventional DNS
server is not used.
5. SLP: Shows information about the current Service Location Protocol (SLP)
connection. SLP is used by network management applications for device
management. The device supports SNMPv1 protocol on IP networks.
To print the network configuration page from the device control panel
Press the Setup button, select Print Report, select Network Config, and then press
OK.
Understand the network configuration page (some models only) 127
To Next Page
Loading...