There are three methods to uninstall the software on a Windows computer, and one method to
uninstall on a Macintosh computer.
To uninstall from a Windows computer, method 1
1. Disconnect the device from your computer. Do not connect it to your computer until after you
have reinstalled the software.
2. On the Windows taskbar, click Start, select Programs or All Programs, select the product
name, and then click Uninstall.
3. Follow the onscreen instructions.
4. If you are asked whether you would like to remove shared files, click No.
Other programs that use these files might not work properly if the files are deleted.
5. Restart your computer.
6. To reinstall the software, insert the HP Software CD into your computer's CD drive, follow the
onscreen instructions.
7. Connect the device when the software prompts you to connect it to the computer.
8. Press the Power button to turn the device on.
After connecting and turning on the device, you might have to wait several minutes for all of
the Plug and Play events to complete.
9. Follow the onscreen instructions.
When the software installation is complete, the HP Digital Imaging Monitor icon appears in the
Windows system tray.
To uninstall from a Windows computer, method 2
NOTE: Use this method if Uninstall is not available in the Windows Start menu.
1. On the Windows taskbar, click Start, select Settings, select Control Panel, and then click
Add/Remove Programs.
- Or -
Click Start, click Control Panel, and then double-click Programs and Features.
2. Select the product name, and then click Change/Remove or Uninstall/Change.
Follow the onscreen instructions.
3. Disconnect the device from your computer.
4. Restart your computer.
NOTE: It is important that you disconnect the device before restarting your computer.
Do not connect the device to your computer until after you have reinstalled the software.
5. Insert the HP Software CD into your computer's CD drive and then start the Setup program.
6. Follow the onscreen instructions.
To uninstall from a Windows computer, method 3
NOTE: Use this method if Uninstall is not available in the Windows Start menu.
1. Insert the HP Software CD into your computer's CD drive, and then start the Setup program.
2. Disconnect the device from your computer.
3. Select Uninstall and follow the onscreen directions.
4. Restart your computer.
NOTE: It is important that you disconnect the device before restarting your computer.
Do not connect the device to your computer until after you have reinstalled the software.
5. Start the Setup program for the device again.
Uninstall and reinstall the software 207
To Next Page
Loading...