3. Insert the envelopes with the side you want to print on down, and load according to the graphic.
Ensure that the stack of paper is aligned with the appropriate paper size lines on the bottom of
the input tray, and does not exceed the stack height marking on the side of the tray.
NOTE: Do not load envelopes while the printer is printing.
4. Slide the paper-width guides in the tray until they touch the edge of the stack of envelopes, and
then reinsert the tray.
5. A message appears on the control panel display prompting you to change the paper setting if
you have changed the media type, or retain the setting if you have replaced what was previously
loaded.
6. Pull out the output tray extension.
14 Chapter 2 Get started ENWW
To Next Page
Loading...