3. Set the printer on top of the tray.
CAUTION: Be careful to keep your fingers and hands clear of the bottom of
the printer.
4. Connect the power cord and turn on the printer.
5. Enable Tray 2 in the print driver. For more information, see
Turn on accessories in
the print driver.
Turn on accessories in the print driver
• To turn on accessories on Windows computers
•
To turn on accessories on Macintosh computers
To turn on accessories on Windows computers
1. Click Start, point to Settings, and then click Printers or Printers and Faxes.
- Or -
Click Start, click Control Panel, and then double-click Printers.
2. Right-click the printer icon, and then click Properties.
3. Select the Device Settings tab. Click the accessory that you want to turn on, click
Installed from the drop-down menu, and then click OK.
To turn on accessories on Macintosh computers
The Mac OS automatically turns on all accessories in the printer driver when you
install the printer software. If you add a new accessory later, follow these steps:
1. Open the System Preferences and then select Print & Fax.
2. Select the printer.
3. Click Options & Supplies.
4. Click the Driver tab.
5. Select the options you want to install, and then click OK.
Turn the printer off
Turn the printer off by pressing the Power button located on the printer. Wait until the
power light turns off before unplugging the power cord or turning off a power strip. If
you incorrectly turn the printer off, the print carriage might not return to the correct
position causing problems with the ink cartridges and print quality issues.
Turn the printer off 19
To Next Page
Loading...
