5. Turn the device on its right side. There are three catches that must be released. Use a small flat
blade screwdriver to release the catch on the back of the printer (callout 1) and the bottom of the
printer (callout 2). Then open the top of the printer and release the catch on the inside (callout 3).
Once all three catches are released, rotate the cover towards the front of the device and remove
it.
Figure 4-5 Remove side covers (3 of 4)
Figure 4-6 Remove side covers (4 of 4)
Back Cover
1. Remove the front cover. See Front Cover on page 40.
2. Remove the control panel. See
Control panel on page 40.
3. Remove both side covers. See
Side Covers on page 41.
ENWW Covers 43
To Next Page
Loading...