4. Remove one grounding screw (callout 1).
Figure 4-7 Remove back cover (1 of 2)
5. Lift plate in three of the four corners (callout 2) to pop the plate off. Use a small flat blade screwdriver
to get leverage on each of the corners.
Figure 4-8 Remove back cover (2 of 2)
Top Cover
1. Remove the front cover. See Front Cover on page 40.
2. Remove the control panel. See
Control panel on page 40.
3. Remove both side covers. See
Side Covers on page 41.
4. Remove the back cover. See
Back Cover on page 43.
44 Chapter 4 Removal and replacement ENWW
To Next Page
Loading...