9. As you remove the power supply, note the location of the non-captive grounding spring (callout 9).
You might need to reinstall the spring before reinstalling the power supply.
9
Figure 5-36 Grounding-spring locations
Reinstallation tip To reinstall the oblique-roller assembly, slide the tab (callout 10) in first and
then insert the other side of the assembly. Rotate the roller toward the back of the device to align
the gears. Verify that the roller lever (callout 11) is not misaligned.
102 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...