Gear assembly
1. Remove the following components:
●
All covers (see
Covers on page 69)
●
Formatter (see
Formatter on page 80)
●
ECU (see
Engine control unit (ECU) on page 88)
●
High-voltage power supply (see
High-voltage power supply on page 97)
2. Remove the two switch link assembly screws (callout 1), slide the assembly toward the front of the
device, and then lift it out of the device.
3. Remove three cables from the cable guides (callout 2).
NOTE Make sure that you duplicate the cable routing upon reinstallation.
1
2
Figure 5-41 Removing the gear assembly (1 of 3)
108 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...