Connecting the Cables
The cable connections required depends on whether you will operate the monitor as a stand-alone
Internet monitor (Net mode) or as a standard external monitor connected to a PC (PC mode).
NOTE: You can connect the cables for both Net mode and PC mode and switch between the two
modes by pressing the Mode button on the front of the monitor.
Connecting the Cables for Net Mode
1. Place the monitor in a convenient, well-ventilated location.
2. Connect an active Ethernet cable to the Ethernet port on the monitor's rear panel.
Figure 2-6 Connecting the Ethernet Cable
ENWW Connecting the Cables 7
To Next Page
Loading...
