Switch cover
Description Spare part number
Switch cover (includes LED board and cable) 468820-001
Before removing the switch cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 32).
5.
Remove the keyboard (see
Keyboard on page 42).
Remove the switch cover:
1.
Close the computer.
2.
Turn the computer upside down, with the rear panel toward you.
3. Remove the two Phillips PM2.5×7.0 screws (1) and the four black Phillips PM2.0×4.0 screws (2)
that secure the switch cover to the computer.
4.
Turn the computer right-side up, with the front toward you.
5.
Open the computer as far as possible.
6. Release the ZIF connector (1) to which the LED board cable (2) is connected, and disconnect the
cable from the system board.
44 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
