Display assembly
Description Spare part number
13.3-inch, WXGA BrightView display assembly (includes camera/microphone module, camera/
microphone module cable, 2 microphones, and 3 wireless antenna transceivers and cables)
468806-001
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 32).
5.
Disconnect the wireless antenna cables from the WLAN module (see
WLAN module on page 34).
6.
Remove the following components:
a.
Keyboard (see
Keyboard on page 42)
b.
Switch cover (see
Switch cover on page 44)
c.
Top cover (see
Top cover on page 45)
Remove the display assembly:
1.
Close the computer.
2.
Turn the computer upside down, with the rear panel toward you.
3. Remove the two Phillips PM2.5×7.0 screws (1) that secure the display assembly to the computer.
50 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
