2. Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.
3. Connect the other end of the Ethernet cable to an available port on your Ethernet
router, switch, or wireless router.
4. Once you have connected the HP All-in-One to the network, install the software as
described in “
Install the software for a network connection” on page 16.
Integrated wireless WLAN 802.11 network setup
For optimal performance and security in your wireless network, HP recommends you use
a wireless router or access point (802.11) to connect the HP All-in-One and the other
network elements. When network elements are connected through a wireless router or
access point, this is called an infrastructure network.
Integrated wireless WLAN 802.11 network setup 9
Network setup
To Next Page
Loading...