3. Press until Advanced Setup is highlighted, and then press OK.
4. Press
until IP Settings is highlighted, and then press OK.
If the HP All-in-One is already connected to a wired network, you are prompted to
confirm that you want to change the IP settings. Press OK.
5. Press
until Manual is highlighted, and then press OK.
6. Press
to highlight one of the following IP settings, and then press OK.
• IP Address
• Subnet Mask
• Default Gateway
7. Enter your changes, and then press OK to confirm the setting.
Chapter 2
20 Network setup
Network setup
To Next Page
Loading...