HP Photosmart Premium C309 series - Page 13

HP Photosmart Premium Fax All-in-One series-C309 • 13
If you have additional computers on your
network, install the HP All-in-One software
on each computer.
Follow the onscreen instructions. Make sure that
you choose the connection types between the
network and your HP All-in-One (not between
your computer and the network).
Network Troubleshooting
Problem: After you run the Wireless Setup Wizard from the HP All-in-One control panel, the HP All-in-One
cannot connect to the network.
Action:
Run the Wireless Network Test. You can run this diagnostic test directly from the Wireless Setup Wizard
or from the HP All-in-One front panel Network Menu. In the Network Menu, scroll down and select
Wireless Network Test. After the test runs, a report is printed that lists any problems detected with
your wireless network, along with recommendations on how you can correct it.
There may be inference from other devices preventing the HP All in One from connecting. Any wireless
device that uses 2.4GHZ can cause interference (including microwaves). Make sure these devices are
not in use during the HP All in One installation.
Your wireless router may need to be reset. Turn off your wireless router for 30 seconds and then turn it
back on. Then run the Wireless Setup Wizard on your HP All in One.
•
•
•
D2 - Ethernet/ Wireless (802.11)
/
www.hp.com/support
EN AR
EN AR
EN
AR