EasyManua.ls Logo

HP PhotoSmart R607 - Recharging the Lithium Ion Battery

HP PhotoSmart R607
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE When you remove the Battery from the camera, the
date and time settings are preserved for approximately
10 minutes. If the camera is without a Battery for longer
than 10 minutes, the clock is set to the last date and time
at which the camera was used. You may be prompted to
update the date and time the next time you power on the
camera.
Recharging the Lithium [on
Battery
The rechargeable HP Photosmart R07 lithium ion battery can
be recharged in the camera when the camera is connected to
the HPAC power adapter or optional HP Photosmart R-series
dock. The lithium ion battery can also be recharged with the
optional HP Photosmart Battery quick recharger or in the spare
battery bay of the HP Photosmart R-seriesdock. SeeAppendix
B: Purchasing Camera Acces_ries on page 161.
When the HPAC adapter is used to charge the battery and the
camera is off, the Power/Memory light on the back of the
camera will blink during charging. When the dock is used, the
dock light will blink. When the quick recharger is used, the
light on the quick recharger will be yellow.
Thefollowing table shows the average time it takes to recharge
a battery that has been fully discharged, depending on where
the battery is being charged. Thetable also notes the signal
you will seewhen the battery has been recharged.
Appendix A: Managing Batteries 157

Table of Contents

Related product manuals