12 Upgrading and Servicing Guide
3 Disconnect the power and data cables from the back of the drive. For the HP Pocket
Media Drive bay, squeeze the two latches on the connector and pull the plug.
4 Pull the drive out through the front of the chassis.
Adding or Replacing the HP Pocket Media Drive
Bay, Diskette, or Hard Disk Drive
1 Complete the procedures to remove the drive, if necessary. See “Removing the
HP Pocket Media Drive Bay, Diskette, or Hard Disk Drive” on page 11.
2 Slide the HP Pocket Media Drive bay, diskette (floppy), or hard disk drive part way
into the front of the chassis.
To CPU
SLAVE
MASTER
To Next Page
Loading...
