Reverse this procedure to reassemble and install the solid-state drive.
Memory module
Description Spare part number
8-GB (PCL3, 12800, 1600) 693374-005
4-GB (PCL3, 12800, 1600) 691740-005
2-GB (PCL3, 12800, 1600) 691739-005
Before removing the memory module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 24).
5. Remove the bottom cover (see Bottom cover on page 26).
Remove the memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
2. Remove the memory module (2) by pulling it away from the slot at an angle.
Reverse this procedure to install a memory module.
32 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
