Power connector cable
NOTE: The power connector cable is included in the Cable Kit, spare part number 809856-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 24).
5. Remove the bottom cover (see Bottom cover on page 26).
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the retention clips (2) built into the base enclosure.
3. Remove the Phillips PM2.5×8.6 screw (3) and the two Phillips PM2.5×5.8 screws (4) that secure the
display left hinge to the base enclosure.
4. Swing the left display hinge (5) to the open position.
5. Remove the power connector cable (6).
Reverse this procedure to install the power connector cable.
Component replacement procedures 47
To Next Page
Loading...
