Speakers
Description Spare part number
Speaker Kit (includes left and right speakers, cables, and four rubber isolators) 809870-001
Before removing the speakers, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 24), and then remove the following components:
a. Bottom cover (see Bottom cover on page 26)
b. Hard drive (see Hard drive on page 28)
c. WWAN module (see WWAN module on page 33)
d. Keyboard/top cover (see Keyboard/top cover on page 48)
e. System board (see System board on page 55)
Remove the speakers:
1. Release the speaker cable from the routing clip (1) built into the base enclosure.
2. Remove the two Philllips PM2.0×5.5 shoulder screws (2) that secure the speakers to the
base enclosure.
Component replacement procedures 61
To Next Page
Loading...
