3. Remove the fingerprint reader board (4) from the computer.
To install the fingerprint reader board, reverse this procedure.
Fan
To remove the fan, use this procedure and illustration.
Table 6-4
Fan descriptions and part numbers
Description Spare part number
Fan for use in models with UMA 15 W models N96441-001
Fan for use in models with UMA or discrete 28 W models N96442-001
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 36).
2. Remove the bottom cover (see Bottom cover on page 36).
3. Disconnect the battery cable from the system board (see Battery on page 47).
Remove the fan assembly:
1. Disconnect the fan cable from the system board connector (1).
2. Remove camera cable from the clip (2) on the fan.
3. Remove the three Phillips 2.0 × 4.0 screws (3) that secure the fan to the computer.
Fan
51
To Next Page
Loading...
