11. Flex the top (3) of the bezel, the inside edges of the left and right sides (4), and then the bottom (5) of
the bezel until it disengages from the display enclosure.
NOTE: Make sure the hinges are not bent (see hinge position in following image) when you remove the
bezel.
12. Remove the display bezel (6).
The display bezel is available using spare part number 721934-001 for models with a webcam and
721935-001 for models without a webcam. Display bezel mylar screw covers are available in the
Rubber Kit, spare part number 721948-001.
84 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
