7.
Lift the bezel (4) until it disengages completely.
8. If it is necessary to replace the webcam module, gently pull the webcam module away from the
double-sided tape on the display enclosure (1) and disconnect the webcam cable from the module
(2). The webcam module and cable can be ordered by using spare part number 598671-001.
NOTE: To replace the webcam module in the display enclosure, align the holes on the webcam
module with the pins on the display enclosure and press onto the double-sided tape.
9. If it is necessary to replace the display hinges, remove the six Torx M2.5×5.0 screws (1) that
secure the hinges to the display housing.
100 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
