5.
Remove the two Phillips PM2.5×5.0 screws that secure the keyboard to the computer.
6. Slide the keyboard back toward the display (1), and then rotate it forward (2) until it rests upside-
down on the palm rest.
7. Release the zero insertion force (ZIF) connector (1) to which the keyboard cable is attached, and
disconnect the keyboard cable (2) from the system board.
NOTE: Only disconnect the keyboard cable from the system board when replacing the
keyboard or removing the top cover. It is not recommended that you disconnect the cable unless it
is absolutely necessary.
58 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
