h. Display assembly (see Display assembly on page 59)
i. Top Cover (see
Top cover on page 65)
j. Heat sink and fan (see
Heat sink and fan on page 74)
Remove the RJ-45 (network) jack:
1. Disconnect the RJ-45 (network) cable from the system board (1) and remove the tape (2) that
secures the cable to the base enclosure.
2. Lift the RJ-45 (network) jack (3) straight up from the retention clips to remove it.
Reverse this procedure to install the RJ-45 (network) jack.
Component replacement procedures 77
To Next Page
Loading...
