l. Leave the computer upright on the table for 10 minutes to be sure that the panel sits correctly in the
display.
m. Open the display and remove rubber spacer strips.
n. Replace the hinge cover by positioning the cover over the bottom of the display, rotating the cover
upward, sliding it to the left, and then replacing the screw.
9. If you need to remove the hinge cover from the display enclosure:
a. Remove the Phillips M1.2 × 3.0 screw (1) that secures the hinge cover to the display.
b. Slide the hinge cover toward the right (2).
c. Rotate the bottom of the hinge cover up, and then remove it from the display (3).
d. Note the location of all cables that are hidden by the hinge cover so that you can be sure to properly
route the cables during reassembly.
The hinge cover is available in the Plastics Kit, spare part number M30663-001.
10. If you need to remove the hinges from the display enclosure:
a. Remove the three Phillips M2.5 × 10.0 screws (1) from each hinge.
Display assembly
67
To Next Page
Loading...
