Removal and replacement procedures
Maintenance and Service Guide 4ā51
ā
When installing the display bezel, it may be necessary to replace the double-sided tape that secures
the bezel to the display enclosure. The tape should be installed in the locations shown in the
following illustration.
14. If it is necessary to replace the webcam module:
a. Release the webcam module 1 as far from the display enclosure as the webcam module cable allows.
(The webcam module is attached to the display enclosure with double-sided tape.)
b. Disconnect the webcam module cable 2 from the webcam module.
c. Remove the webcam module 3. The webcam module is available using spare part number 583219-001.
To Next Page
Loading...
