3. Release the ZIF connector (2) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable (3) from the TouchPad board.
Reverse this procedure to install the TouchPad cable.
TouchPad
NOTE: The TouchPad spare part kit does not include the TouchPad bracket or the TouchPad cable. The
TouchPad cable is included in the Cable Kit, spare part number 917064-001. The TouchPad bracket is not
spared as a separate component.
Description Spare part number
In radiant red nish 917051-001
In smoke gray nish 917052-001
Before removing the TouchPad, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 18).
Remove the TouchPad:
1. Turn the keyboard/top cover upside down with the front edge toward you.
2. Detach the adhesive strip (1) the secures the TouchPad and TouchPad cable to the keyboard/top cover.
3. Release the two pieces of grounding tape (2) that secure the TouchPad to the keyboard/top cover.
Component replacement procedures 23
To Next Page
Loading...
