Solid-state drive
Description Spare part number
256-GB, M.2, SATA-3 solid-state drive 917099-001
128-GB, M.2, SATA-3 solid-state drive 917098-001
Before removing the solid-state drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 18).
5. Remove the battery (see Battery on page 27).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the bottom cover.
(The solid-state drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
28 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
