2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description Tool Size (if
applicable)
Phillips (Cross-slot) screwdriver
Torx T-10 Screwdriver
Torx T-15 Screwdriver
Description #4
Description #5
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove Power Supply - Qty 1 or 2 - see illustration below
2. Remove Fan Tray - see illustration below
3. Remove top cover - 10 screws on top
4. Remove CR2032 battery - Qty 1
5. Remove PCA mounting screws
6. Remove PCAs - Qty. 3 - from chassis
7.
8.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00 Page 2
Template Revision A
To Previous Page
Loading...
