Removal and replacement procedures 27
To replace the component, reverse the removal procedure.
Mezzanine assembly
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Place the server blade on a flat, level work surface.
4. Remove the access panel ("Access panel" on page 24).
5. Remove the mezzanine assembly.
To replace the component:
1. Align the mezzanine assembly with the guide pins on the system board, and then install the mezzanine
assembly on the system board.
To Next Page
Loading...
