Removal and replacement procedures 64
To remove the PCI cage:
1. Perform the pre-installation procedure.
2. Disconnect all cables connected to an existing expansion board.
3. Remove the PCI cage.
a. Remove the four PCI cage screws: one near the system fan 4, one near the half-length/
low-profile riser board, and two on the rear panel (1).
b. Remove the PCI cage from the chassis (2).
To reinstall the PCI cage:
1. Align the PCI cage with the system board expansion slots, and then press it down to ensure full
connection to the system board.
2. Reinstall the five PCI cage screws to secure the cage to the chassis.
To Next Page
Loading...
