Removal and replacement procedures 80
6. Remove the new 500W power supply unit from its protective packaging.
7. Install the 500W power supply unit.
a. Insert the two tabs located on the left side of the power supply underneath the system board.
After that make sure the PSU screw holes are aligned with those on the chassis (1).
b. Insert the one screw near the PSU fan (2)
c. Insert the two screws on the right side of the chassis (3).
d. Insert the two screws securing the PSU to the chassis base (3).
8. Attach the PSU bracket.
To Next Page
Loading...
