Removal and replacement procedures 35
6.
Remove the optical drive assembly.
To replace the component, reverse the removal procedure.
Fan
To remove the component:
1. Power down the server (on page 24).
2. Remove the server from the rack (on page 24).
3. Remove the access panel ("Access panel" on page 25).
4. Remove the air baffle ("Air baffle" on page 25).
5. Disconnect the fan cable from the system board.
6. Remove the fan.
To replace the component, reverse the removal procedure.
Expansion board
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCIe riser board assembly.
To Next Page
Loading...
