HP ProLiant DL120 G7 - Page 43

Removal and replacement procedures 43
3.
Install the heatsink, and then insert and tighten the two screws.
4. Install the air baffle.
5. Install the access panel.
6. Install the server into the rack.
7. Power on the server.
Processor
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack (on page 24).
4. Remove the access panel ("Access panel" on page 25).
5. Remove the air baffle ("Air baffle" on page 25).