Removal and replacement procedures 54
Figure 30 Backplane connectors (solder side)
Item Description
1 Header for backplane aligns to backplane inter-connection
2 SATA Signal Cable Connector
3 SGPIO header
4 PSOC F/W programming header
5 4- pin power connector
WARNING: Ensure that the system is powered off and all power sources have been disconnected
from the server. Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in the off position.
To remove the backplane:
1. Remove all drives out of the drive bays.
Refer to the Hard drives sections in this chapter for detailed procedures.
To Next Page
Loading...
