Removal and replacement procedures 70
Figure 55 Replacing the battery
System board removal and replacement procedure
To remove the system board:
1. Remove the top cover.
2. Loosen the nine screws that secure the system board to the chassis.
3. Slide the system board back, up and out of the chassis. Remove the system board from the
chassis.
Figure 56 Removing the system board
To replace the system board:
1. Align the system board I/O connectors to their openings and slide the system board into place.
The nine screw holes on the chassis should align with the system board.
2. Fasten the nine screws on the system board to secure the system board to the chassis.
To Next Page
Loading...
