Removal and replacement procedures 72
3.
Slide the hot-plug power supply out of the power supply bay.
Figure 59 Removing the hot-plug power supply
To replace the hot-plug power supply:
1. Align the hot-plug power supply cage connector with the open slot of power supply, and slide
the hot-plug power supply into the power supply bay until it snaps into place.
2. Snap the latch cover over port colored handle. Latch cover only installs one way.
Figure 60 Installing the hot-plug power supply
System fan
The server has six system fans located on the chassis’ center wall.
The figure below identifies the system fans by their device number and shows their corresponding
cable connections.
To Next Page
Loading...
