Hardware options installation 48
12.
Install the drive into the drive bay.
13. Connect the cable from the rear of the drive to the SATA DVD-ROM drive connector on the system
board.
14. Install the PCI riser cage. ("Install the PCI riser cage" on page 21)
15. Install the processor air baffle.
16. Install the access panel (on page 19).
17. Slide the server into the rack.
18. Connect each power cord to the server.
19. Connect each power cord to the power source.
20. Power up the server (on page 17).
21. If removed, install the rack bezel (on page 60).
To Next Page
Loading...
