Hardware options installation 61
7.
Remove the adhesive stickers from the VGA cable clips, and then attach the clips onto the fan cage.
8. Route the cable through the cable clips, and then connect then cable to the VGA card and power supply
cable.
9. Install the processor air baffle. ("Install the processor air baffle" on page 20)
10. Install the access panel.
11. Slide the server into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server (on page 17).
15. If removed, install the rack bezel (on page 60).
Mini-SAS cable option
The server supports the 700 mm mini-SAS cable option.
To Next Page
Loading...
