HP ProLiant DL160 Gen8 - Non-Hot-Plug Drive

Removal and replacement procedures 35
3.
Remove the drive.
To replace the component, reverse the removal procedure.
Non-hot-plug drive blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Remove the non-hot-plug drive blank.
To replace the component, reverse the removal procedure.
Non-hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 27).