Removal and replacement procedures 44
Figure 13 Hard Drive Configuration / 4 3.5” HDD Non-hot-plug Model
Item Description
1 1
st
SATA hard drive
2 2
nd
SATA hard drive
3 3
rd
SATA hard drive
4 4
th
SATA hard drive
The hot-plug HDD for the servers with 2 3.5” HDDs and 4 3.5” HDDs share the same replacement
procedures. Here we take the server with 4 3.5” HDDs as an example for your reference.
To remove the hot-plug hard drive:
1. Press the hard disk carrier button to release the ejector lever.
2. Use the HDD carrier latch to pull the drive out of the cage.
Make sure to support the drive when pulling it out of the cage.
3. Pull the hard drive assembly out of the drive bay.
To Next Page
Loading...
