Removal and replacement procedures 76
Dedicated management port (Optional)
The server can support a dedicated management port. The dedicated management port is optional for
the shipment.
The following figure shows the dedicated management port location.
Figure 61 Dedicated management port Location
To remove the dedicated management port:
1. Remove the PCI cage assembly out of the chassis. Refer to the “PCI expansion card ” section in
this chapter for detailed procedures.
2. Loosen the screw.
3. Pull the dedicated management port upwards, and then remove the dedicated management port
from the dedicated management port connector.
Figure 62
Removing the Dedicated management port
4. Remove the spacer from the system board.
To Next Page
Loading...
