Hardware options installation 50
b.
Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 23).
5. Remove the access panel (on page 24).
6. Use a flathead screwdriver to carefully pry the blanks from the box 1 drive bays 1-4.
Retain the blanks for future use.
7. Remove the primary PCI riser cage ("Remove the PCI riser cages" on page 26).
8. Remove the air baffle (on page 28).
9. Disconnect the fan cables.
10. Remove the fan cage.
11. Install the 4-bay LFF hot-plug drive cage backplane:
a. Insert the guide tabs on the rear of the cage into the corresponding backplane slots.
To Next Page
Loading...
