Removal and Replacement Procedures 50
Figure 30 DIMM slots
• Channel 1 -- DIMM1 and DIMM2
• Channel 2 – DIMM3 and DIMM4
NOTE: Before installing the memory, remove the air baffle first, for detailed procedure, refer to the
‘Processor’ section in this chapter.
To remove memory module:
1. Completely open the holding clips securing the module.
2. Gently pull the memory module upward to remove it from the slot.
Figure 31 Removing a memory module
CAUTION: Place the memory module on a static-dissipating work surface or inside of an anti-static
bag.
To Next Page
Loading...
