Removing and replacing a processorRemoving and replacing a processor
Hewlett Packard Enterprise recommends identifying the processor and socket components before performing this procedure.
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-20 screwdriver
Thermal grease (spare part number 777298-001)
Alcohol wipe
ProcedureProcedure
1. Observe the following alerts.
CAUTION: CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace
or install the processor in this server.
CAUTION: CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor configurations
must contain processors with the same part number.
CAUTION: CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support CenterHewlett Packard Enterprise Support Center
websitewebsite.
CAUTION: CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or
processor, do not touch the contacts.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
5. Remove the access panel.
6. Remove the air baffle.
7. Allow the heatsink to cool.
8. Remove the heatsink:
CAUTION:CAUTION:
To prevent mechanical damage or depositing oil on your hands or other contaminants to the heatsink contact
surface, hold the heatsink only by the edge of its baseplate. Do not touch the heatsink fins.
CAUTION:CAUTION:
Heatsink screws must be tightened and loosened in alternating sequence as shown on the heatsink label.
a. Use a T-20 screwdriver to loosen the captive screws in the sequence specified on the heatsink label.
b. Lift the heatsink away from the system board.
To Next Page
Loading...
