HP ProLiant DL345 Gen10 Plus - Removing and Replacing the M.2 SATA SSD Add-In Card

Removing and replacing the M.2 SATA SSD add-in cardRemoving and replacing the M.2 SATA SSD add-in card
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you a T-10 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack
4. Remove the access panel.
5. Disconnect any internal cables that are connected to the expansion board.
6. Remove the riser cage.
7. Remove the M.2 SATA SSD add-in card.
8. Remove the M.2 SATA SSD.
Removing and replacing the M.2 SATA SSD add-in card 111